| Cracked exhaust header [message #784462] |
Fri, 21 July 2006 20:59 |
|
well, my 97 wrangler exhaust header finally cracked. The leak sounds
horrible and my gas mileage has started dropping. I need to replace the
header for not a lot of dough. any recommendations for a new header? What
about any gotchas during the replacement?
The sad part is, I'm looking to sell this jeep, but I doubt if anyone would
buy it with an exhaust leak. I hate fixing something just to turn and sell
it.
Thanks,
Dennis
|
|
|
| Re: Cracked exhaust header [message #784466 ] |
Fri, 21 July 2006 21:10 |
|
you can buy the manifold online for around 100 bucks.. if yer a diy'er drop
the motor mount and come up through the bottum it takes an hour to an hour
1/2.. the local shops around here..charge 150-175 bucks instalation if you
bring the part, but Im in Houston
--
"Dennis Cox" <dennis_coxremove [at] removeverizon.net> wrote in message
news:Gu9wg.38$yN3.1 [at] trnddc04...
> well, my 97 wrangler exhaust header finally cracked. The leak sounds
> horrible and my gas mileage has started dropping. I need to replace the
> header for not a lot of dough. any recommendations for a new header?
> What about any gotchas during the replacement?
>
> The sad part is, I'm looking to sell this jeep, but I doubt if anyone
> would buy it with an exhaust leak. I hate fixing something just to turn
> and sell it.
>
> Thanks,
> Dennis
>
|
|
|
| Re: Cracked exhaust header [message #784478 ] |
Fri, 21 July 2006 23:53 |
|
"Dennis Cox" <dennis_coxremove [at] removeverizon.net> wrote in message
news:Gu9wg.38$yN3.1 [at] trnddc04...
> well, my 97 wrangler exhaust header finally cracked. The leak sounds
> horrible and my gas mileage has started dropping. I need to replace the
> header for not a lot of dough. any recommendations for a new header?
> What about any gotchas during the replacement?
>
I did it on my 99 ,I just followed the procedure in my Haynes manual. Bought
the manifold for about 100 bucks, came with a gasket. If you replace the
gasket you have to remove the intake manifold and everything attached. Not
too hard, took me 3 or 4 hours one Sunday to do it. The bolts are a bit of a
pain to torque down once everything is all put back together. I had to use a
few different length extensions and universal joints.
Jerry S.
|
|
|
