| Top molding filling up with water :( [message #475173] |
Mon, 10 October 2005 17:14 |
|
Weird problem. Passenger side. On the top above each side window
there's the rubber molding that the side window seals agains. That
moulding is 2 halfs where the bend for the top is. The front 1/2
closest to the windshield got damaged and I replaced it with a new one
I bought from the dealer. Well it started to leak and I thought at
first the water was coming in from the window not sealing correctly
but that's not the case. The molding itself is filling up with water!
They are hollow and the water is geting inside it. When I drive the
motion of the car drives all the water out all over my passenger
seat. I've looked at the placement of the molding several times,
compared it to the drivers side. Had a friend look at it (to get
another set of eyes on it) and it looks like it's installed
correctly. It's really a simple piece so I can't understand what's
wrong. Anyone see this issue before or have any ideas?? Thanks.
--
Scott Streeter
ss [at] wpi.edu
http://www.wpi.edu/~ss/
|
|
|
| Re: Top molding filling up with water :( [message #475177 ] |
Mon, 10 October 2005 20:49 |
|
Scott Streeter wrote:
> Weird problem. Passenger side. On the top above each side window
> there's the rubber molding that the side window seals agains. That
> moulding is 2 halfs where the bend for the top is. The front 1/2
> closest to the windshield got damaged and I replaced it with a new one
> I bought from the dealer. Well it started to leak and I thought at
> first the water was coming in from the window not sealing correctly
> but that's not the case. The molding itself is filling up with water!
> They are hollow and the water is geting inside it. When I drive the
> motion of the car drives all the water out all over my passenger
> seat. I've looked at the placement of the molding several times,
> compared it to the drivers side. Had a friend look at it (to get
> another set of eyes on it) and it looks like it's installed
> correctly. It's really a simple piece so I can't understand what's
> wrong. Anyone see this issue before or have any ideas?? Thanks.
You need to be extremely observant. In my P5, the rear left door was
removed, repaired and replaced after a ding. The new gasket "almost" set
correctly, so I heard road noise. I found that the attachments are a
series of burred plastic fasteners, and that the rubber gasket was not
only hollow, but had tiny holes every few inches. I eventually got it
right and the car is now quieter, but it was not easy.
Look at every gasket fastener, gasket fit, turn and clearance. all
clearances are to be closed when the door is shut, but there must be a
drain route for water that makes it to that gasket.
If the gasket is filling with water, such holes as I mentioned are a
possible entry point. Or it may be that other lower holes are meant to
be drains ("weep holes") and are not open. Examine one or more other
vehicle(s) of the identical make and model. Look carefully at all such
details as I described. Only when the last detail is satisfied will you
be completely dry.
Angelo Campanella
|
|
|
| Re: Top molding filling up with water :( [message #475178 ] |
Mon, 10 October 2005 22:36 |
|
In article <7ju0fps8tz.fsf [at] ccc10.wpi.edu>,
Scott Streeter <ss [at] ccc10.wpi.edu> wrote:
> Well it started to leak and I thought at
> first the water was coming in from the window not sealing correctly
> but that's not the case.
Correct. It's probably because the drain in the windshield frame is
clogged. Find the hole in the funny-looking rubber molding at the top
corner of the A pillar. Water should drain down that hole and run onto
the ground under the car. If it doesn't, run a flexible wire down the
hole--carefully!--until it's clear.
---
Lanny Chambers
'94C, St. Louis
http://www.hummingbirds.net/alignment.html
|
|
|
| Re: Top molding filling up with water :( [message #475184 ] |
Tue, 11 October 2005 16:27 |
|
Thanks guys. I'll try your suggestions.. Once it stops raining
around here. :P
--
Scott Streeter
ss [at] wpi.edu
http://www.wpi.edu/~ss/
|
|
|
